Make your own remote for the Canon EOS 300D (500, 500N, 50(e), ElanII and more...)

an alternative for the Canon RS60-E3 remote by Marco

The Circuitry

There are 2 ways of connecting:

Circuit Diagram 1: This is the original wiring as Canon uses it, SW1 and 2 are the momentary switches and 3 is the toggle switch.

Fot the 300D however you can use this diagram:

Circuit Diagram 2: Here SW 1 and 2 are again the momentary switches and 3 and 4 are toggle switches. 3 for BULB or continuous drive 4 to lock AF, using this switch you can force the camera to use all servo AF. This setup does was not tested on older models (i.e. 50(e), 500, Elan II etc.)

>> BACK